Does anyone know the correct way to feed two antennas at one time
in NEC2?
I've tried feeding a single segment with transmission lines (TL) to each
antenna, and
I've tried using two sources (EX - voltage?) set at half magnitude. Results
were similar
in both cases (and the stack was better than either antenna by about 3db), but
I'm not
convinced I'm doing it correctly.
It seems like I should use two current sources and specify the phase on the EX
line.
Any idea how to do this?
Thanks
--Lee - KT4ZX
leewells@lexmark.com
--
FAQ on WWW: http://www.contesting.com/antennaware-faq.html
Submissions: antennaware@contesting.com
Administrative requests: antennaware-REQUEST@contesting.com
Problems: owner-antennaware@contesting.com
|