Here, the paralleled pair of Jennings RJ2B output vac relays are
installed.....along with the 7-16 DIN output connector.
Also installed is the 1/2" silver plated tubing coil, used for 20 + 15m.
Also installed is the hb 3/8" tubing coil, used for 80+40m. The hb cu
discs
are cut and installed for the vac tune and vac load caps. The hb 1/4"
tubing coil (used for 160m) is wound, but not yet installed, nor the 100mm
diam Draloric plate block cap. On the rear apron, you can also see the
pair of 100 amp, superior electric ...'supercon connectors', used to
terminate the cables for the 7.0 vac @ 78 amp fil supply. It's progressing
pretty good. The entire B+ supply has yet to be built... but is a straight
forward project, since it's already been done several times before.
https://www.youtube.com/watch?v=ZdQU5HuonqA
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|