Hello Jim
Does that clamping diode across the coil affect the TX key up delay time? As in
"slow it down"?
73
Tim K3LR
-----Original Message-----
From: Amps [mailto:amps-bounces@contesting.com] On Behalf Of MU 4CX250B
Sent: Sunday, December 11, 2022 5:49 PM
To: Steve London
Cc: amps@contesting.com
Subject: Re: [Amps] Noisy relay
Steve, you might be hearing the induced voltage kick caused by the
inductance of the coil. Try putting a clamping diode. A small signal
diode like a 1n914 will work fine,
73,
Jim w8zr
Sent from my iPhone
> On Dec 11, 2022, at 9:39 AM, Steve London <n2icarrl@gmail.com> wrote:
>
> Commander HF-2500..
>
> Every time the T/R relay goes back to receive, I'm getting a pretty big RF
> spike that I can hear in the receiver. This has nothing to do with the
> transceiver hot switching or RF stored in the tank circuit. I can reproduce
> it just by cycling the T/R relay in the amp with a separate cable, not
> connected to the transceiver, and not transmitting.
>
> Suggestions ?
>
> 73,
> Steve, N2IC
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|