John,
Did you need info for a QRO HF 2000?
JAY, K2ZT
On Thu, Feb 20, 2020, 11:26 PM John Keating <john.keating@outlook.com>
wrote:
> I'm looking for a procedure/recommendation on proper setting of the
> trimmer caps on the RF input and output of a QO HF 2000 amp. They are
> located right at the SO-239s. The input cap is in circuit (to ground) all
> the time; the output cap is in circuit (to ground) when the amp is not
> keyed (so the two are in parallel in that condition). I checked the input
> with the antenna analyzer and the output into 50 ohm dummy load, it's not
> wildly off 50 ohms across the HF band but it does vary -- 50 -j0 ohms at 4
> MHZ, 51 +j4 ohms at 7MHZ, 56 +j5 ohms at 10MHZ, 60 +j0 ohms at 14MHZ, 58
> -j8 ohms at 18MHz, 53 -j10 ohms at 21MHZ, and 43 -j4 ohms at 28MHZ. That
> makes the "bypass" condition SWR 1.25 in spots.
>
> AI6LY
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|