I think you guys are discussing something unrelated to my inquiry.
73 - Mark N5OT
On 2/14/2020 8:14 AM, Jim Thomson wrote:
<The biggest stations run (at least) two radios on each band, one "running" (calling
CQ) and the other in S&P mode (tuning up and down the band for <multiplers).
<http://k9yc.com/Multi-Station.pdf provides an overview of all of the
mechanisms that can couple RF between stations.
<73, Jim K9YC ## I read the pdf. Mark is referring to FULL DUPLEX...with
TX and RX, simultaneously..on the SAME freq.Per your PDF, that would
require 2 x yagis, several hundred feet apart, with booms parallel to each
other. That only would work In 2 x directions. Ditto with perhaps 2 x dipoles
end to end...and several Hundred feet apart.BP filters, stubs etc, dont
enter into the equation. What about all the other directions ?? ## what if
a single vertical is used on... say 160/80/40m ...and a 2nd vertical /
dipole for RX?? I find the concept of full duplex on <5 acres, really
hard to believe. The signal intensity on ground wave for verts is intense.
## when I was a commercial radio op back In 1974, the TX + RX ants were
10 miles apart, hence full duplex on 400-500 khz cw. ## Buddy of mine
was 75m mobile...coming over to my home. I just about did In th
e
front end of his poor Icom.I shut it all down, asap, when he was
1400 feet down the street. ## older ham, across the street from my
folks home, back In the 70s, would know asap when I was on the
air. Hiswatt meters, rf ammeters, you name it, would dance up +
down...with all his gear shut off. Jim VE7RF
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|