Amps
[Top] [All Lists]

Re: [Amps] Tips For Winding a Plate Choke

To: Doug Renwick <ve5ra@sasktel.net>, hzp_electronics@juno.com, amps@contesting.com
Subject: Re: [Amps] Tips For Winding a Plate Choke
From: Colin Lamb <k7fm@teleport.com>
Date: Sun, 06 Oct 2019 17:10:25 -0700
List-post: <mailto:amps@contesting.com>
W8ji has all the information.  Wind the coil and measure it.  Suppose someone 
gives you a choke and it is not tested.  Then you have fireworks?K7fm  
colinSent from my Galaxy Tab A
-------- Original message --------From: Doug Renwick <ve5ra@sasktel.net> Date: 
10/6/19  12:16 PM  (GMT-08:00) To: hzp_electronics@juno.com, 
amps@contesting.com Subject: Re: [Amps] Tips For Winding a Plate Choke Hi,I am 
looking for tips on how to set up and physically place the wire on theform. 
W8JI omits that information.I was hoping that some of the amp gurus here wound 
a plate choke and wouldshare that information, but so far no luck.Doug "The 
difference between stupidity and genius is that genius has its limits."Albert 
Einstein -----Original Message-----From: hzp_electronics@juno.com 
[mailto:hzp_electronics@juno.com] Sent: October-06-19 12:46 PMTo: 
ve5ra@sasktel.netSubject: Re: [Amps] Tips For Winding a Plate ChokeTom W8JI 
gives a lot of information on winding and testing plate chokes.  Hedesigned the 
ones for some MFJ amps.https://www.w8ji.com/rf_plate_choke.htm    ; GL,.... Bill 
K3HZP---------- Original Message ----------From: "Doug Renwick" 
<ve5ra@sasktel.net>To: "'Jim'" <jimw7ry@gmail.com>, 
<amps@contesting.com>Subject: Re: [Amps] Tips For Winding a Plate ChokeDate: 
Sat, 5 Oct 2019 21:59:30 -0600The Ameritron plate choke is too long; won't fit. 
My only choice is torewind it.Doug"The difference between stupidity and genius 
is that genius has its limits."Albert Einstein -----Original Message-----From: 
Amps [mailto:amps-bounces@contesting.com] On Behalf Of JimSent: October-05-19 
9:53 PMTo: amps@contesting.comSubject: Re: [Amps] Tips For Winding a Plate 
ChokeSave yourself some headaches, and buy an Ameritron choke from MFJ. They 
work very well. They are about $30.00 or 35.00.Thanks73Jim W7RYOn 10/5/2019 
9:37 PM, Doug Renwick wrote:> I need to re-wind a plate choke. I could use any 
tips for this procedure.> Doug>> Canada; the ship of fools where corruption and 
politics are synonymous>>>> ---> This email has been checked for viruses by 
Avast antivirus software.> https://www.avast.com/antivirus>> 
_______________________________________________> Amps mailing list> 
Amps@contesting.com> 
http://lists.contesting.com/mailman/listinfo/amps_______________________________________________Amps
 mailing 
listAmps@contesting.comhttp://lists.contesting.com/mailman/listinfo/amps_______________________________________________Amps
 mailing 
listAmps@contesting.comhttp://lists.contesting.com/mailman/listinfo/amps____________________________________________________________Oncologists
 Are Freaking Out Over True Cause of 
Cancerhealthresponses.orghttp://thirdpartyoffers.juno.com/TGL3131/5d9a36b719f1c36b66fd0st03vuc_______________________________________________Amps
 mailing 
listAmps@contesting.comhttp://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
<Prev in Thread] Current Thread [Next in Thread>