Do you see the same thing when you view the program on a local computer
monitor, or only when viewing it remotely through TeamViewer?
If you've only viewed the Alpha 9500 remote software through TeamViewer,
try these suggestions:
https://lifehacker.com/how-to-get-the-best-experience-from-teamviewer-1585428616
73,
Bob, N6TV
On Wed, May 8, 2019 at 5:54 AM noll amidzich <namidzich@wi.rr.com> wrote:
> I recently installed the remote software for my Alpha 9500 purchased new in
> 2013.
>
>
>
> The CD supplied is version 1.14.
>
>
>
> Upon installation, noticed several of the Front Panel screen display
> HEADINGS (NOT the actual values) "Flicker" ...example, band, tune, load,
> meter AC, options, control
>
>
>
> Also the SWR display will only show increments of 1 . ie. 1 or 2. Nothing
> in
> between. Power output will show wattage including 1 decimal to the right of
> 0. (Example 1150.6 watts)
>
>
>
> I've been told version 2.01 looks exactly like the 9500 front panel. What I
> have, does not.
>
>
>
> Went to Alpha website in hopes of downloading the latest version. Unable to
> do so as the link for downloads was taken down.
>
>
>
> I'm currently remoting using TeamViewer 13.
>
>
>
> Software works to the extent of being able to remotely turn amp on/off,
> switch bands, display output , plate voltage, current etc.
>
>
>
> Questions I have..
>
>
>
> Why the screen flickering?
>
>
>
> Would going to a later Alpha remote software version cure the "flicker"?
>
>
>
> How would I even get the latest version, whatever it may be? And from
> where?
>
>
>
> Thanks
>
>
>
> Noll W9RN
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|