I guess you didnt bother reading and understandng my post relating to the
"4CX800A"
It never was and will never be an Eimac product. They are a fraud by several
US hams including a former Eimac engineer who decied to revive surplused
Russian military tubes, revise specs to their own needs and make a huge
profit. That group has long been disbanded and amp owners left hanging in
the wind.
You can still buy new 3CPX800A7's from Eimac and Ive had good luck with the
Chinese versions built with Eimac supplied tooling and instructors. These
can also be purchased from Ameritron when they buy stock for the AL-800 and
800H.
I never got suckered into the "low grid current" scam.
Carl
----- Original Message -----
From: "Steve London" <n2icarrl@gmail.com>
To: <amps@contesting.com>; <km1h@jeremy.qozzy.com>
Sent: Monday, April 01, 2019 3:34 PM
Subject: Re: [Amps] QRO 2500DX MARK lll 4CX800
So, Carl, where would you suggest us cheap, constantly crying, hams get
new, or at least new-old-stock Eimac 4CX800's and 3CX800's ? Lotsa luck.
73,
Steve, N2IC
On 04/01/2019 09:08 AM, Carl wrote>>
Unlike Eimac, Philips and similar manufactures who design tubes for CCS
service along with plenty of reserve emission to compensate for aging.
that
tube and most amateur service Chinese are run at the edge. And cheap
hams
cry constantly.
Carl
---
This email has been checked for viruses by AVG.
https://www.avg.com
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|