Sounds like a bad tube
Sent from AOL Mobile Mail
Get the new AOL app: mail.mobile.aol.com
On Saturday, March 16, 2019, Bob Gibson via Amps <amps@contesting.com> wrote:
I have a problem that just came up with my QRO amp..First I blew a 1/2a fuse on
the bias board..I replaced it turned it back on then a 1/2a fuse blew on the LV
and bias board again but not the same fuse..Screen voltage is OK and HV is OK.
When I hit with 10 watts the fault light comes on and kicks the amp off and I
see the grid current meter go all the way over..I see no burnt parts or smell
parts...could this be a grid short in one of the tubes? I have pulled the tubes
and nothing looks bad below..I think I will send the tubes down and have them
check just to make sure it is not a problem with one of them..Bob W5RG
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|