Amps
[Top] [All Lists]

Re: [Amps] HV rectifier diodes

To: Mark Schoonover <mark@ka6wke.net>, Art <ky1k@myfairpoint.net>
Subject: Re: [Amps] HV rectifier diodes
From: Joe <nss@mwt.net>
Date: Mon, 28 Jan 2019 09:18:36 -0600
List-post: <mailto:amps@contesting.com>
How about equalizing resistors?

Joe WB9SBD
Sig
The Original Rolling Ball Clock
Idle Tyme
Idle-Tyme.com
http://www.idle-tyme.com
On 1/27/2019 2:28 PM, Mark Schoonover wrote:
Art,

Take a look at 1N5408 diodes. I'm using these in a desktop kilowatt
project. If they'll work for you send me sase and I'll send you what you
need. I got a deal on a bulk purchase.

73! Mark KA6WKE

Website: https://www.ka6wke.net
Live Stream: https://www.ka6wke.net/live-stream
Facebook: https://www.facebook.com/ka6wke-live-stream
Twitter: https://www.twitter.com/ka6wke
EMail Announcement: ka6wke-announce+subscribe@groups.io
Author: 4NEC2 The Definitive Guide
EMail List:: 4nec2defguide@groups.io

On Sun, Jan 27, 2019, 10:28 Art <ky1k@myfairpoint.net wrote:

Hi All,

When I joined the list, it was to get the skinny on solid state amps,
little did I realize that my tube type amp would die and I'd be
consulting the list for HV diode suggestions and vendors.

But:

I have a bottom end amp, 400 watts out, an AL84. The plate voltage
dropped from just under 1kV (unloaded) to 600v and obviously the power
output is way down. I assume I need new rectifiers.

The manual says it uses 1kV @ 3 amp diodes, 8 of them total, in a full
wave bridge rectifier configuration. The part number is AR-145, which
isn't available, it's likely an Ameritron house number. The voltage
rating of each diode seems marginal to me though (to me).

I looked in Digikey and Mouser, they don't don't carry them.

There are no equalizing caps or resistors, so I'd prefer to put in a
single 4kV diode rather than deal with 2 diodes in each leg of the
bridge. Barring that, I'd like to replace all 8 diodes with 2kV @ 2 amp
diodes.

Are there any reputable vendors that sell these lower voltage diodes at
a reasonable price, I would prefer NOT to use the online auction site::>

Would appreciate any comments or suggestions.

TY

Art

_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps



_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>