Victor,
I have made a lot of RF measurements on small relays at power levels up
to 400w. I have also measured operate and release times.
http://www.w0qe.com/Technical_Topics/small_signal_relays_at_rf.html
http://www.w0qe.com/Technical_Topics/relay_operate-release_tester.html
73,
Larry, W0QE
On 12/4/2018 3:21 AM, Victor Rosenthal 4X6GP wrote:
I'm trying to choose a relay to use as the input relay in a QSK amp.
I have been very satisfied with the Jennings RJ1-A as an output relay.
The input relay in this circuit needs to be DPDT, or I'd just use two
similar vacuum relays.
Here are my needs:
1. DPDT.
2. 12 or 24v coil.
3. Operate/release time, including bounce <= 4 ms. Faster is better.
4. Should carry 100w RF in 50 ohm system. Not expected to make/break
live circuit.
5. Must have low resistance for low-level signals (receive path).
6. Must have long life >= (10 x 10**6 operations)
7. Must not be insanely expensive, and available from Mouser or RS.
I found this relay:
<https://www.mouser.co.il/datasheet/2/418/NG_SS_108-98005_L-1019204.pdf>
But maybe there's a better choice? I'm overwhelmed by the number and
varieties of relays in the catalog.
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|