Ameritron will sell you a complete switch only, Electroswitch will not deal
with an individual and the switch is the same as the old Centralab 2500
series.
Those switches were used in all sorts of commercial and industrial gear,
finding a compatble switch or just the wafe at a hamfest, Ebay, one from a
SB-1000 with a melted front wafer on 160, etc might be your only resort.
One other thought which I havent checked in ages is the Harbach 6 postiion
replacement wafer for the SB-220 series. Im not at home and this phone has
too poor a resolution!
Carl
----- Original Message -----
From: "Bill Coleman" <aa4lr@arrl.net>
To: "Amps Reflector" <amps@contesting.com>
Sent: Friday, July 27, 2018 4:42 PM
Subject: [Amps] AL-80A - Pi/Pi-L Switch Wafer Failure due to arcing
I have an Ameritron AL-80A, which unfortunately during the KH1/KH7Z
expedition experienced bandswitch arcing when used on 17m in the 20m
bandswitch position. (Oops!)
The arc melted the contact on the Pi/Pi-L switch wafer. The contact at the
40m position is just gone, and the wiper has a bit of a corner melted off.
I have experience in replacing switch contacts, so that’s no problem, but
I’m a little worried about the condition of the wiper. How hard is it to
obtain a replacement switch wafer?
Amp is still running. I soldered a bit of hook-up wire so that it is
permanently in the Pi position — so I can’t run it on 160 or 80m. But I
would like to fix it.
Any ideas?
Bill Coleman, AA4LR, PP-ASEL Mail: aa4lr@arrl.net
Web: http://boringhamradiopart.blogspot.com
Quote: "Not within a thousand years will man ever fly!"
-- Wilbur Wright, 1901
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
---
This email has been checked for viruses by AVG.
https://www.avg.com
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|