I recommend 10 Ohms. I use 2 resistors and 2 relays. There are fuses in
series with the resistors to protect them.
Why would a cap blowing up cause an issue with a step start circuit?
Again, I use 2 resistors and 2 relays on a small circuit board.
See:
https://www.ebay.com/itm/282765541853?ssPageName=STRK:MESELX:IT&_trksid=p3984.m1555.l2649
73
Jim W7RY
-----Original Message-----
From: Arnie Pfingst
Sent: Tuesday, December 26, 2017 8:31 PM
To: amps@contesting.com
Subject: [Amps] Soft Start
Once upon a time, i had a capacitor explode upon start up. I've heard
stories for and against adding a soft start circuit to my amplifiers.(Some
say 20 ohm resistors, and others say 30 or 40 ohm.) That and the price of
replacement tubes. In my case i have two TL 922a amps using 3-500z tubes.
Both set up on 240vac. What do you all have to say here. Thanks
Arnie
Sent via the Samsung Galaxy S8 Active, an AT&T 4G LTE smartphone
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|