I'm sure a search for "softening lock-tight" will lead you to the proper
solvent...
73
Jim W7RY
-----Original Message-----
From: Victor Rosenthal 4X6GP
Sent: Friday, December 08, 2017 7:43 AM
To: Alek Petkovic
Cc: Amps reflector
Subject: Re: [Amps] Stuck setscrews
I'm sure those would do the job. More than the job, unfortunately.
73,
Victor, 4X6GP
Rehovot, Israel
Formerly K2VCO
http://www.qsl.net/k2vco/
On 8 Dec 2017 14:50, Alek Petkovic wrote:
Angle grinder or oxy torch.
On 8/12/2017 7:27 PM, Victor Rosenthal 4X6GP wrote:
I have an older Palstar AT-Auto tuner. It uses stepper motors to turn a
rotary inductor and a capacitor. It works very well in my station (or it
did).
The motors are connected to the coil and capacitor with semi-flexible
insulated couplings that are made out of some kind of plastic strip. The
plastic on the one for the capacitor has disintegrated. I have a good
quality metal and ceramic coupling to replace it with, but I can't budge
the setscrews holding the old one. Allen wrenches twist to no effect.
The screws are held with some kind of glop. I don't think it is Loctite
but I don't know for sure. I put some penetrating oil on them and am
waiting to see if that works.
I suppose I could drill them out if needed, but that is a last resort
because I am afraid of damaging the motor or the capacitor. Any
suggestions?
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|