Lots of stuff on the Repeater Builder site about Bird Slugs. Just search
for Repeater builder bird slugs.
73
Jim W7RY
-----Original Message-----
From: Paul Baldock
Sent: Wednesday, October 25, 2017 7:49 PM
To: amps@contesting.com
Subject: Re: [Amps] Bird Slug Modification?
After receiving some good tips about the coupling of a 5W slug being
too tight to convert to a 1KW slug with just a resistor change, I've
decided to move the pickup further from the transmission line. After
a little experimenting this seems to work. I only need it to be
accurate on 50MHz, so if I screw up the bandwdith it will not really matter.
- Paul
At 05:17 PM 10/25/2017, donroden@hiwaay.net wrote:
Google a QST slug calibration article from a few years ago.
Don W4DNR
Quoting Paul Baldock <paul@paulbaldock.com>:
I have a 5W 50-125MHz slug. Can I turn it into a 1KW slug by adding
a suitable series resistor?
Thanks
- Paul KW7Y
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|