Update: just checked the transformer primary: appears to be fine (both halves).
Put it back together and turned it on again, and was surprised to see Vp now at
1700 volts, then realized that was in SSB, so it's still 1kv low.
At 1700 volts, I can get about 600w on 40,20 and 15. Which, accounting for
efficiency, is probably right about what you can expect for 1kw DC.
So am I right in thinking all signs point to the HV circuit? Something in the
voltage doubler? Could a leaky bypass cap (which is upstream of the ‘fuses’ (a
pair of 1 ohm resistors paralleled and in series between PS and plate choke)
drag down the voltage?
(In case you’re just arriving in this thread: yes, the primary circuit is wired
correctly for 120v; no, the circuit board has not been rewired to accommodate
811s, no fuses blow and no smoke has been released (yet).)
73, kelly, ve4xt
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|