Amps
[Top] [All Lists]

Re: [Amps] SB 220 Exploding Resistor

To: "Jim W7RY" <w7ry@centurytel.net>, <donroden@hiwaay.net>
Subject: Re: [Amps] SB 220 Exploding Resistor
From: "Carl" <km1h@jeremy.qozzy.com>
Date: Tue, 19 Jan 2016 18:30:31 -0500
List-post: <amps@contesting.com">mailto:amps@contesting.com>
That is only good in early amps, a Heath bulletin had a simple wiring change, no convoluted voodoo mod needed.

Only needed when on 240V

Carl
KM1H


----- Original Message ----- From: "Jim W7RY" <w7ry@centurytel.net>
To: <donroden@hiwaay.net>
Cc: "AMPS" <amps@contesting.com>
Sent: Monday, January 18, 2016 10:56 AM
Subject: Re: [Amps] SB 220 Exploding Resistor


Yes there is. Move R27 to me in series with the 120 volt bias and the center tap of the filament transformer. So if a there is a filament to grid short, it wont short out the 120 volt bias supply.

From Rich Measures web site...

If one of the tubes happens to develop a filament-to-grid short: Since each grid is DC-grounded, a shorted tube also short-circuits the +110V power supply. This power supply is powered by the unfused filament-transformer. Thus, if a filament-to-grid short occurs, and the amplifier is not switched off promptly, the filament-transformer will literally melt-down and short-out. The black tar that comes out of the overheating transformer makes an unpleasant mess inside the amplifier. This potential source of grief can be eliminated if the relay is rewired as shown in Diagram 1. The new circuit uses resistor-cutoff bias, utilizing the existing 100k ohm resistor [R27], which is rewired to relay terminal #5. The current through this resistor, during receive, is normally less than 0.25mA [P<0.007W], so the 1/2W rating is more than adequate. (In other words, it is risky to connect a power supply to the bias contacts of any grounded-grid amplifier.


73
Jim W7RY



-----Original Message----- From: donroden@hiwaay.net
Sent: Monday, January 18, 2016 7:24 AM
To: Jim W7RY
Subject: Re: [Amps] SB 220 Exploding Resistor

Jim,

I have a SB220 upside down and I'm guessing that there is a
modification to prevent damaging the filament transformer ( ?? )


Don W4DNR

_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps


-----
No virus found in this message.
Checked by AVG - www.avg.com
Version: 2015.0.6176 / Virus Database: 4522/11438 - Release Date: 01/19/16


_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>