sure you didnt hit the HI-LO VOLTAGE switch on power supply while reinstalling?
73,
Richard
-----Original Message-----
From: CenturyLink Customer <idahogn@q.com>
To: amps <amps@contesting.com>
Sent: Mon, May 4, 2015 8:14 pm
Subject: [Amps] titan 425 low output power
hello all,
i have a titan 425 that was returned by tentec ( 700 dollar
repair bill) with a clean bill of health ( had a wafer switch replaced) when
taken out of the box the amplifier will only make 1000 watts pep with 100 watts
of drive. i use to make 1000 watts with 20 watts worth of drive. thought a tube
got damaged. replaced with new eimacs and it does the exact same thing. any
ideas on what could be wrong? this is the second and last time i will use
tentec. not a good experience.
where should i start?
shawn
_______________________________________________
Amps mailing
list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|