Hi
I just bought a new to me amplifier (Alpha 89) that I have run into a
problem. I was tuning up on 75m (Into a Dummy Load) and all
of a sudden I could smell something burning, and at the same time I lost all
output power. I was still getting a grid current reading
of roughly 35ma, not sure of the plate current as the meter was on the tune
scale.
I immediately shut the amplifier off and turned off the mains. I pulled the
cover off and did a good visual inspection for anything
that looks like it has been burnt or destroyed. I could find nothing that
looks suspect.
I put the cover back on and turned on the mains. I turned the amp back on
and it went through it's 3 minute wait cycle ok with
no issues. I put the amp into the opr posn and gave it a bit of RF and all
apears to be working fine, however something went
wrong previously as I couldsmell something burning.
I am sure someone must have experienced this before and could point me in
the right direction of where I should be looking.
Thanks in advance.
73, George
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|