If you are planning to use it as an AM linear at times running about 7-8V
bias will be more efficient and not hurt SSB IMD.
Ive been using my LK-500ZC that way for years and confirmed on a spectrum
analyzer.
The same procedure works on other amps and tubes.
Carl
KM1H
----- Original Message -----
From: "Jim W7RY" <w7ry@centurytel.net>
To: <amps@contesting.com>
Sent: Thursday, December 25, 2014 1:14 AM
Subject: Re: [Amps] L4B biasing
11 diodes (7 volts) is way too much bias voltage.
Better to have about 3 diodes (1N5408). That is what I have found while
designing my QSK circuit board for the Drake. The L4 and L4B was designed
with Amperex 8802 tubes. They did not require
bias because the idled at a much lower current than Eimac 3-500 tubes. And
the old L4 was designed around the 3-400 (8163) which did not require bias
either.
Sure, if you have 3800 volts of plate voltage then 7 volts of bias is
fine. The SB220 used a 5.1 volt zenner and the SB220 plate voltage was
around 3200 volts.
73
Jim W7RY
-----Original Message-----
From: Paul Baldock
Sent: Wednesday, December 24, 2014 1:23 PM
To: mikflathead@aol.com ; amps@contesting.com
Subject: Re: [Amps] L4B biasing
Yes you should add bias. I added 11 diodes in the center tap of the
filament trany. So that would be about 7 volts.
- Paul
.At 12:52 PM 12/24/2014, you wrote:
I just finished me Drake power supply. I used a Drake transformer and a
doubler board with 8 caps. I have 2600 volts showing on the high voltage
meter. I have eliminated all the bias circuit in the power supply that
Drake used. At idle I show 200 mills of plate current. My question is
should I add a bias circuit? I purchased a W4ZT board but wonder if I need
it. Thanks and Happy Holidays to all.
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
---
This email has been checked for viruses by Avast antivirus software.
http://www.avast.com
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
-----
No virus found in this message.
Checked by AVG - www.avg.com
Version: 2015.0.5577 / Virus Database: 4257/8805 - Release Date: 12/25/14
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|