Amps
[Top] [All Lists]

Re: [Amps] AL-1200

To: Louis Parascondola <gudguyham@aol.com>, "Amps@contesting.com" <Amps@contesting.com>
Subject: Re: [Amps] AL-1200
From: Bob Gibson via Amps <amps@contesting.com>
Reply-to: Bob Gibson <w5rg@yahoo.com>
Date: Wed, 24 Dec 2014 18:45:19 +0000 (UTC)
List-post: <amps@contesting.com">mailto:amps@contesting.com>
I have added a WD7S ABOARD WHICH HAS 10 FILTER CAPS ON IT..I do need to 
check the input voltage and the wires to the transformer.. that is one thing I 
have not done..I replaced the step start because he has trouble before with the 
original relay and resistor burning out.. With the original P/S board the 
diodes would blow, now with the newer WD7S boards, the filter caps pop.. I know 
the last time I replaced the board it was one of mine that I had in a AL-1500 
so I know it worked before I switch it out on his.. He lives in OKLA and I live 
in Florida so I'm headed back up on Friday to help him out.. Bob W5RG  Almost 
60 years in Ham Radio

      From: Louis Parascondola <gudguyham@aol.com>
 To: w5rg@yahoo.com; Amps@contesting.com 
 Sent: Wednesday, December 24, 2014 12:34 PM
 Subject: Re: [Amps] AL-1200
   
Yes, make sure the plate transformer is NOT using the green wire instead of the 
brown/white lead.  If the green wire is used it can very well up the HV to 3900 
volts will eventually stress out the filter caps and they will let go.  This is 
exacerbated further buy very high line voltage.  Some people could have up to 
250v.  Also it is prudent to modify the capacitor system to use 10 capacitors.  
I make a homebrew kit with instructions on how to install it to add 2 more 
caps.  Unless the amps blows up right away at turn on there is NOT a problem 
with anything else.    -----Original Message-----
From: Bob Gibson via Amps <amps@contesting.com>
To: Amps <Amps@contesting.com>
Sent: Wed, Dec 24, 2014 12:51 pm
Subject: [Amps] AL-1200



 I'm having a problem with a friends al-1200 amp.. He is 80 years old  I'm 71 
and we can not figure this out.. I have replaced the stock P/S board twice.. 
after a short time it blows out.. I have replaced it now with a WD7S HV board 
and again it blows the caps.. I have replaced the step-start board with a W7RY 
board.. still samething.. I headed back up to try to work on this thing again 
this weekend.. any ideas would sure help out..Bob W5RG  Almost 60 years in Ham 
Radio
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

 

  
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
<Prev in Thread] Current Thread [Next in Thread>