Re: [Amps] AL80B power meter not working

[Steve Thompson <g8gsq72@gmail.com>]

A minor point, not really relevant to your test - 1N914 is a 
'regular' diode like 1N4148 except that 1N4148 has lower leakage.
I mention it only to avoid disappointment should someone grab a 
1N914 for a situation where a shottky is essential.
Steve
> Well, as something easy to try, I replaced the two detection diodes on the
> power supply board.  I didn't have the germanium 1N34s, so I used some
> 1N914 schottky diodes that I had, just to verify if this was the issue.
> And now both forward and reflected meter indications seem to be working
> fine.  In standby, with 100 W from my radio, the meter indicates 0.1 kW.
> So, these diodes seem to be working well in this circuit.  In CW mode, I
> can tune to an indicated 800W into a dummy load at 14.250 with about 70W of
> drive.  I did order some 1N34As off of ebay, and I'll replace the schottky
> diodes when these come in.  But for now, I'm a happy camper.
>
> Thanks, and 73.
>
> John, K8DIL/AE
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps