Hi Mike,
Yes, I tried, not much luck. Just the AS and pictures.
Actually I am looking for templates for cutting, drilling and bending the
cabinet's sheets.
73,
Felipe
Felipe Ceglia - PY1NB
-------------------------------------------------------------------------------------
PR1T team member /// Rio DX Group member /// Araucaria DX Group member
http://dxwatch.com /// http://reversebeacon.net /// http://riodxgroup.com
On Tue, Sep 30, 2014 at 7:19 AM, mike via Amps <amps@contesting.com> wrote:
> Did you try Google? That should be all over the net. Mike
>
>
>
>
>
>
> -----Original Message-----
> From: Paul <paul@g4dcv.co.uk>
> To: amps <amps@contesting.com>
> Sent: Tue, Sep 30, 2014 2:24 am
> Subject: Re: [Amps] W6PO 2m amp drawings
>
>
> Hi Felipe
>
> http://www.landfall.net/Radio/8877-1.htm
>
> 73 Paul G4DCV
>
> On 30/09/2014 01:42, PY1NB - Felipe Ceglia wrote:
> Hello,
>
> By any chance, would anyone here have the drawings for building the rf
> deck/cabinet for a W6PO 8877 2m amp? (eimac application note AS-47)
>
> 73 and thanks in advance,
>
> Felipe Ceglia - PY1NB
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|