Remember that you need to measure the voltage under full load.
On 9/8/14 2:09 AM, glenn riccio wrote:
Hello all you henry radio amp owners. I just bought a Henry 3k filament
xfrmer off the internet. It is supposed to deliver 7.5 v @ 21 amps. There
are taps on the primary side to adjust output . I cannot get less than 8.75
volts out. My input voltage is 240vac. I tried all the taps on the primary
side using #1 as the common leg. It is a EC1216a transformer. I want to use
it for my 4-1000a amp I'm building.
I suppose I could call or e-mail henry radio but they might be annoyed that
I'm not using it for one of there amps. Any help would be appreciated. 73
Glenn K7gfr
--
Vic, K2VCO/4X6GP
Rehovot, Israel
http://www.qsl.net/k2vco/
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|