I bought a used Amp supply LK-500ZB. Met the ham on his way to Dayton so I
wasn't able to check it out beforehand. So of course it has a problem.
This amp has the QSK board with a qsk switch on the back. All the
schematics I have seen have 5 relays on the qsk board while this one only
has 3 relays.
There is no continuity from the input to the output when powered off.
Therefore no receive signal passes trough. Also the transmitter goes to
high swr. I know at a minimum that the vacuum relay is bad.
I have the following questions:
Are the vacuum relays high failure ?
Anything that typically causes them to fail.
Any other thoughts as to what might be bad ?
Does anybody have a schematic of the qsk board with only 3 relays ?
Best place to buy a replacement vacuum relay ?
Any other mods or thoughts while I am working on it ?
Thanks in advance.
--
Mike Stokes
KK9V
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|