Hello Matt,
I've been using Tyco RTB14012F SPDT relays (12 V DC ~30 ma. nominal op.
current) in all my remote antenna switching arrangements. Run 1500 Watts
RTTY, SO2R. All the relays are controlled by non-hot switching circuit
made up of a single IC and some xsistors (circuit has been published).
Digikey, Mouser, etc. carry them.
73,
Mike, K4GMH
On Fri, May 9, 2014 at 5:41 PM, Matt <maflukey@gmail.com> wrote:
> I would appreciate recommendations for general purpose SPDT relays that can
> be used reliably for RF antenna switching duty - it is not a hot switching
> application. I am aware that the DC & 60hz AC ratings are not necessarily
> indicative of RF performance.. any experience out there?
>
>
>
> Thanks in advance.
>
>
>
> Matt
>
> KM5VI
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|