On 1/9/2014 8:55 PM, krishna kanakasapapathi wrote:
Folks,
The KPA500 is in a remote setup and i tried to upgrade from 1.23 to
1.33 over the remote setup.
The connection dropped and the amp did not recover.
The On/Off front panel does not respond. Power cycling the amp has
not made it go back to the
older version either.
The front panel display says "MCU Load".
I am going to call Elecraft tomorrow, but thought i will drop a note
to check if anyone has the magic
procedure to recover.
You should be asking this question on the Elecraft reflector, which
several Elecraft engineers (including owner-engineers N6KR and WA6HHQ)
read every day. It's rare to have to wait more than half a day for a
useful response, and I've seen N6KR respond in a few hours to a
DXpedition with a problem.
73, Jim K9YC
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|