I sent basically the same comment four hours ago, but such are the marvels of
the internet, it has disappeared. probably resurface ina couple of months.....
But, yes, I totally agree with Gary.
73
Peter G3RZP
========================================
Message Received: Dec 28 2013, 09:14 PM
From: "Gary Schafer" <garyschafer@comcast.net>
To: "'Roger'" <ai7rogerroger@gmail.com>, amps@contesting.com
Cc:
Subject: Re: [Amps] Runaway Plate Current
Are the screens getting grounded when you remove the screen voltage?
If not that will cause runaway plate current.
73
Gary K4FMX
> -----Original Message-----
> From: Amps [mailto:amps-bounces@contesting.com] On Behalf Of Roger
> Sent: Saturday, December 28, 2013 12:16 AM
> To: amps@contesting.com
> Subject: [Amps] Runaway Plate Current
>
> Trying to finish up my 6m Junk Box Amp. Quad 4x150a's, 1700v anode,
> ~355vdc
> screen, ~ -55v bias. Input terminated in 50ohms, output terminated in
> 50ohms. Keying the amp with no excitation to adjust idle current all
> goes
> well. Idle current adjustable from ~150ma to 400ma +. Screen current is
> ~
> -8ma depending on idle current. Grid Current is 0. As soon as I unkey,
> which removes the screen voltage, plate current goes through the roof
> forcing an instant shutdown. Anybody have an idea what might be causing
> this
>
> 73, Roger
> AI7RR
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|