If the choke is going to get hot, I'd be wary of Q dope, as it may well start
melting. I've had decent results with minimal loss of Q with some of the 5
minute epoxy cements.
73
Peter G3RZP
========================================
Message Received: Nov 29 2013, 03:39 PM
From: "iain macdonnell - N6ML" <ar@dseven.org>
To: "AMPS" <amps@contesting.com>
Cc:
Subject: [Amps] Adhesive for plate choke?
I'm going to attempt to rewind a plate choke for my AL-1200, using the
old form from the one I blew before. What is the recommend adhesive
for this application? I've read about home-brew "Q-Dope"[1] - would
that work? Other suggestions? I'd prefer something that's not going to
be flammable when in use...
73,
~iain / N6ML
[1] http://www.cliftonlaboratories.com/coil_coating_compounds.htm
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|