Those switches are good for at least 20 amps, so parallleling contacts is
unnecessary, especially as for bandswitches, you don't (or shouldn't!) hot
switch. Stacking sections to turn them into n-pole switches (which I think is
probably what you want) is more difficult; some probably 20 years or so ago,
there was an article in CQ magazine about doing that. It really needs workshop
facilities, but is possible. Two of them would give a 2pole 6way switch.
73
Peter G3RZP
========================================
Message Received: Apr 06 2013, 12:44 AM
From: "B Osburn"
To: amps@contesting.com
Cc:
Subject: [Amps] Band switch
Has anyone tried paralleling contacts on this switch by stacking sets
vertically using 0.100" spacers? Thinking about using this approach for my tank
circuit band switch for my 4CX1500B push-pull amp project.
One pole 6-POSITION CERAMIC TAP SWITCH for 100 W BC-375 / BC-191 transmitter
tuning unit.
Brad AB0YD
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|