Farnell carries genuine Molex. I have ordered pins and housings there,
though only the 4 pin kind that is used by the new radios. Could check the
PN in Monday.
73, Val LZ1VB
----- Original Message -----
From: "Bob K6UJ" <k6uj@pacbell.net>
To: "Amps reflector" <amps@contesting.com>
Sent: Saturday, March 30, 2013 5:34 PM
Subject: Re: [Amps] Molex Pins
So our best bet is to order from Icom ?
Bob
K6UJ
On Mar 30, 2013, at 8:29 AM, Jim W7RY wrote:
Cant buy them from Mouser. I too went through the exercise. And most of
the plugs/pins that you buy on the net, (quick silver, The RFC etc) the
female
pins are too big for the male pins of the radio.
At The RFC, the pins the sell with the plugs that are a different
configuration and wont plug into the radio, are fine.
But the pins they ship with the plugs that do plug into the radio, are
too big and fit very loosely.
Good luck!
73
Jim W7RY
-----Original Message----- From: Col. Paul E. Cater
Sent: Saturday, March 30, 2013 6:16 AM
To: Amps reflector
Subject: [Amps] Molex Pins
This is an obvious case of brain flatulence. I have ordered 4 different
part numbers from Mouser for the *pins* only that fit the power
connectors
on Icom and other rigs. The standard 6 hole kind. I still don't have
the
correct size.
Anyone have a part number for these off the top of their head? Male &
female.
Thanks,
Paul
WD8OSU
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|