the new amp LK500ZB and I continue our bonding process :)
I've wired up the QSK circuit and recorded the CW signal on my scope. I
can see a small bump after each dot and dash, like on the picture here
http://goo.gl/74HO3
Does it look like hot keying the amp? There is also a very sharp fall off
- the dot is supposed to be 87ms but cut off early. Is anybody familiar
with the QSK circuit on LZ500ZB and/or have words of wisdom? I wonder if
the QSK circuit has been played with and I can't operate it like this.
(I'm really knew to "QRO" stuff).
73
P.S. Thanks to all for answers regarding the LK500Z output on 10m. I've
been testing and re-testing and now consistently get good power on all
bands.
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|