Pete Smith N4ZR wrote:
I could sure use a simple-minded explanation of how to connect my dual-trace
scope in order to get a
display of system timing. The description below, while I'm sure it is correct,
doesn't get this
history major far enough.
If you use a dual trace 'scope to compare two signal's timing, you need to use "chopped" mode,
not "alternate mode" for the channel switching. Everything else is as you would expect.
--
Ron KA4INM - Youvan's corollary:
Every action results in unwanted side effects.
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|