What about pulling a 100 watt deck from a commercial radio like the
Motorola Maratrac. With enough air they will run CCS.
Now, I realize they are Class C, but you could change the bias with
little effort, and Maratracs are cheap !!
73, Dick, W1KSZ
On Wed, Aug 15, 2012 at 11:40 AM, Larry <larry@w7iuv.com> wrote:
> My big 432 amp needs more drive than the exciter can produce. An IPA of
> 100 watts output or so would fix the problem but I have been unable to
> find what I need to build one (that I like).
>
> In the past, I used tubes or BJT's for this but with the success of my
> FET amps for 144 and 1296, I would like to use a FET for this project.
>
> Since I have a MRF176GU on hand, I would like to obtain a PCB or at
> least 1:1 artwork for a PCB that would work with this device.
>
> Although it's pretty pricey, a MRFE6VP100H would also be acceptable if I
> could find artwork or PCB for it.
>
> Any leads on a board for either of these devices would be appreciated.
>
> Thanks & 73,
>
> Larry - W7IUV
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|