I probably should address this question to the FT-5000 list, but since
this discussion concerns ALC control, it's also appropriate here. There
is a switch on the back of the 5000 called E.ALC. According to the
manual, this switch changes the ALC gain from high to low and vice
versa. It's not clear to me what Yaesu means by ALC gain. Is it the
range of voltages that the exciter responds to for throttling the drive
to the amp? That makes sense, but I've never heard that term before.
Can someone enlighten me?
Thanks and 73,
Joe
K2XX
On 7/28/2012 2:36 AM, Roger (K8RI) wrote:
> On 7/27/2012 3:49 PM, Richard Solomon wrote:
>> So far, I have seen no mention of the current YAESU rigs. Has anyone
>> had a problem with any of them (and I do mean RF overshoot) ?
>>
>> 73, Dick, W1KSZ
>>
>> On Fri, Jul 27, 2012 at 12:39 PM, Jim W7RY<jimw7ry@gmail.com> wrote:
>>> Although the 756 Pro line is notorious for this,......
>>> 73
> I run both the old 756 Pro and the new Yaesu FTDX5000MP with no problems
> from either. The 5000MP drives a tetrode amp generally in class A, but
> sometimes in AB1
>
> 73
>
> Roger (K8RI)
>
>>> Roger (K8RI)
>>>
>>>
>>> What do you base your statement on Roger?
>>> Just hearsay or actual experience? Something on the web? If so, could you
>>> point me to it?
>>>
>>> Thanks
>>> 73
>>> Jim W7RY
>>>
>>> _______________________________________________
>>> Amps mailing list
>>> Amps@contesting.com
>>> http://lists.contesting.com/mailman/listinfo/amps
>> _______________________________________________
>> Amps mailing list
>> Amps@contesting.com
>> http://lists.contesting.com/mailman/listinfo/amps
>>
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|