OK on ancient history (-;
>From the mid 80's to current I either worked in a RF lab with access to some
of the best test equipment or built up a suitable substitute here at home.
What I have found with SS gear that Ive tested (and that is far from all of
them) is that there are sweet spots where the IMD is lowest and it is never
at the advertised output. IMD will drop as the power is reduced to that
sweet spot and then rise again to levels that are worse than at rated
power. I did not try any internal tweaks.
Amps that are tuned for full output and then the Load control adjusted for
heavier loading (LESS C) until the power drops 50W or so at the 1200-1800W
level will have the best IMD. This can be anywhere in the 2-5dB range
depending upon the amp and tubes used.
Carl
KM1H
----- Original Message -----
From: "Jerry Kaidor" <jerry@tr2.com>
To: <amps@contesting.com>
Sent: Friday, July 27, 2012 12:08 PM
Subject: Re: [Amps] Overdrive protection
> Back in the late 70's I had access to some very good test equipment - I
> was working as a bench tech in an instrument shop. I would bring in my
> ham rigs to play. On the spectrum analyzer I would see a fundamental
> and a forest of spurii. Turning down the drive, the fundamental would go
> down, and the spurii would generally remain the same. Thus I came to the
> conclusion that for the best cleanliness - in terms of dB - it was best to
> run an exciter at or near its rated power. Maybe that's changed....
>
> - Jerry Kaidor, KF6VB
>
>
>
>
>
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
>
> -----
> No virus found in this message.
> Checked by AVG - www.avg.com
> Version: 10.0.1424 / Virus Database: 2437/5158 - Release Date: 07/27/12
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|