Let's see....would you seriously hand over $8500 to someone who:
Can't write a grammatically correct advertisement
Says he has an RF power amp but wait....it is "plate modulated by a 4-400"
supposedly employs a 10KW plate dissipation tube but runs on single
phase...with ad copy loaded with all sorts of put-downs disguised as
warnings obviously intended to appeal to those who have more ego than
knowledge...
my answer would be 10-4 good buddy
Rob
K5UJ
On Thu, Apr 5, 2012 at 12:38 PM, Randall, Randy
<Randy.Randall@uchealth.com> wrote:
> Sounds like a monster!
>
> Randy AB9GO
>
> Randy E. Randall AB9GO
> Network Engineer
> UC Health
> Randy.Randall@UCHealth.com
> Phone 513-585-7146
> Fax 513-585-7159
>
> Ham Radio Amp - $8500 (Louisville KY)
>
> Custom Large Home Brew HF With Complete Remote Control Unit. Plate Modulated
> by 4-400a main final transmitter tube 8160 Aka 3CX10000-a7 Single Phase 240 "
> If you don't know what size breaker you need then do not rep lie to this ad"
> must pick up at shop can show full output into dummy load on site. All The
> Iron Can Be Removed Before Transit Or fork lift is there to load Completely
> Documented on Build By E.E And M.E.
> Built To Last. Soft Start / Time Delayed /Dummy Proof / Fully Auto. Its A
> Must See Thing. This Is Not Just for Any One. Receipts On Build Totaling
> $14.800.00 Not Including Labor
> Works Great At Legal Limit on AM & SSB With Very Little Drive. It Has 4 inter
> locks and Ground Fault. " To prevent Electrocution" If this unit is not
> operated Properly and tampered with by a UNSKILLED
> Tech folks " Death Will be The in Results " This is not a toy.
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|