Re: [Amps] Hi Pot Test Procedure?

["B Osburn" <plantrunner5@msn.com>]

Since you are just checking the integrity of the vacuum I just did anode to 
cathode.  RLM may say different. 
Brad AB0YD
  ----- Original Message ----- 
  From: Gary K9GS<mailto:garyk9gs@wi.rr.com> 
  To: AMPS Mailing List<mailto:amps@contesting.com> 
  Sent: Sunday, February 12, 2012 6:09 PM
  Subject: [Amps] Hi Pot Test Procedure?


  What is the proper procedure for Hi-Pot testing a tetrode, in this case 
  a GU74B?

  Apply potential between anode and any other element?  I did see one 
  mention of applying potential between the anode and the nearest grid but 
  is this correct?


  -- 


  73,

  Gary K9GS

  Check out K9NS on the web:  http://www.k9ns.com<http://www.k9ns.com/>
  Greater Milwaukee DX Association: http://www.gmdxa.org<http://www.gmdxa.org/>
  Society of Midwest Contesters: http://www.w9smc.com<http://www.w9smc.com/>

  ************************************************
  _______________________________________________
  Amps mailing list
  Amps@contesting.com<mailto:Amps@contesting.com>
  
http://lists.contesting.com/mailman/listinfo/amps<http://lists.contesting.com/mailman/listinfo/amps>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps