Hi Danny,
You may find this page of interest:
http://qsl.net/wc6w/wc6wamps/index.html?fr62.html
73 & Good morning,
Marv WC6W 310 649 3111
--- On Thu, 1/5/12, Danny Pease <dpease@adams.net> wrote:
> From: Danny Pease <dpease@adams.net>
> Subject: [Amps] plate choke location
> To: Amps@contesting.com
> Date: Thursday, January 5, 2012, 8:07 PM
> What is the drawback to putting the
> plate choke at the low impedance end of
> the tank circuit? If the blocking cap was after the load
> cap, the load cap
> would need to be rated for about the same voltage as the
> tune cap. If the
> blocking cap was between the end of the plate coil and the
> loading cap, what
> kind of current would the cap have to handle?
>
> How does placing the blocking cap at the low impedance part
> of the tank
> affect its value as opposed to the high impedance end of
> the circuit?
>
> NG9R
>
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|