I have my TL-922 on the air. I added a soft-start relay, vacuum relay QSK, and
a bias
switching circuit to cut the tubes off in between keyed elements. I also
strapped the
grids directly to ground (W8JI convinced me), added a 5 ohm series resistor
between the
input circuit and the grid, and a copper strap from the chassis piece that the
tuning
capacitor is on to one of the grounded grid terminals.
I also replaced the VHF choke in the plate circuit with a 15 ohm glitch
resistor. To
improve bypassing for 160m, I added a pair of 0.0024 uf 6kv bypass capacitors
after it. I
added 0.02 uf capacitors from the cold ends of the filament choke to ground.
This TL-922 is the 220-240v model. My line voltage is very close to 240, and
with the amp
wired for 240, I measured 5.25 volts at the filament pins (with a true RMS
Fluke meter). I
put a 15 ohm resistor in series with the primary of the filament transformer,
which
reduced the filament voltage to 4.92V. This also will reduce the voltage on the
pilot
lamps a bit.
I added an operate/stby relay which opens the key line on stby and also
switches the
stby/operate lights. This allows me to remotely enable/disable the amplifier.
Some interesting facts:
The designers apparently INTENDED the original antenna relay to hot-switch on
semi-QSK CW
or with VOX! The little spark gap thingy on the relay is a protective device.
This is
horrible, since it means that the spark gap is all that stands between you and
transmitting into an open circuit. No wonder bandswitches burn up! If you don't
modify the
922 to have faster properly sequenced relays, then you should always use PTT.
The fan is really quiet. Like they say in the horror movies, too quiet. I
wonder about the
cooling of the seals around the tube pins.
Kenwood provided slotted setscrews for the plate caps. It can be very hard to
get a
screwdriver in there to tighten them. Allen heads would be much better. The
setscrews are
some Japanese metric thread. But the setscrews in the knobs are the same thread
but have
Allen heads! I switched them.
--
Vic, K2VCO
Fresno CA
http://www.qsl.net/k2vco/
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|