I have not looked very close at the data sheet but it did occur to me that
in some applications some devices require time to thermally or electrically
stabalize.
But, you may be right. I'll look closer.
73
bill wa4lav
________________________________________
From: amps-bounces@contesting.com [amps-bounces@contesting.com] On Behalf Of
jeff millar [wa1hco@wa1hco.net]
Sent: Sunday, August 21, 2011 9:24 PM
To: amps@contesting.com
Subject: Re: [Amps] MRFE6VP Datasheet
I think the pulse operation applies to the 60:1 VSWR specification.
Effectively, that gives a specification on how fast the control circuit need to
operate.
jeff, wa1hco
On 08/21/2011 08:06 PM, Fuqua, Bill L wrote:
> If it will do 1200W average power CW it should do the same in pulsed mode.
> The question is, why list both unless some application requires that
> particular
> pulse specification. It could be that the product was targeted for that
> application.
> And others (CW).
> 73
> Bill wa4lav
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|