Hi,
I'm thinking about ACOM 1010 6m conversion, did anyone done
that?
I think it using pasiv grid design, so at leats I will have to
change:
- input circuit to extend coverage to 50MHz (to neutralize to
tube input capacitence also at 50 MHz),
- check plate choke for
resonance at 6 m band,
- use smaller section of tune capacitor
(possible to be swithed with vacuum relay)
- add aditional switch
(perhaps at rear side) for switching vacuum relays (for swithing band
switch, smaller section of tune capacitor and tube input compensation
circuit).
- find tap at PI and L coils,
vy 73, Branko, S52V
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|