Hello,
I am building a single band hf amp. I am using two 3-500Z tubes. The specs for
the tubes say
4000 Volts dc max. I keep hearing people volting these tubes in standby above
this voltage
and when they transmit the voltage sags to 4000 vdc or a little below. Is this
bad for the tube?
If I figure correctly 2800 volts ac full wave bridge and after filter caps I
should get 4032 volts dc
2800 X 1.44 am I correct? I will be bombarding you with questions cause I want
to do this right.
Thanks Mike N8FWD
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|