I lost a diode string on an 8x4 string 1N5408 FWB on my single GS35b 6m HB
amp. To whit, 8 5408s per leg of a FWB for a total of 32 diodes. Presumably a
lightening strike / blown lightening arrestor, but now I wonder.
I replaced the diodes on the blown string & tested again- worked fine with
just HV trans running to the bridge. Then, put back together w/ cap bank-
blown fuse again & no solid HV. Checked again, another leg of the FWB blown.
Replaced those 8 5408s & tried again with the cap bank inline. Ergo, another
string was blown. Replaced them, and then tested with just HV & the FWB. No
problem. Then connected the cap bacn (overkill, 12 x 450V in series, nominal
800 MFD Mallories w/ 6 x 27k ohm Rs across each cap) WITHOUT the RF deck
connected, and another audible glitch. Tested all the 5408s in the bank, and 3
of the (just) replaced diodes show x Meg ohm in the WRONG direction (yes, I
tested all before & after installation before poweup). All the rest were fine.
Then, tested each cap in the 12 x 800 MFD bank, and discovered nothing (none
shorted), but on a hunch, tried to tighten each screw, and low and behold,
after 2+ years in service, EVERY screw needed 1/8 to 1/4 turn
to get tight. Question: Could the combined losening of the screws create
enough resistance to draw enough current to blow a diode string in the FWB? I
have checked everything else in the PS, and the common denominator seems to be
the cap bank. Am I missing something?
Without load at least, the high current relay works 100% & the HV
soft-start relay is working 100% as is the 24 volt ps that works the relay.
The 2 second TDR that controls the soft-start is similarly fine.
The 250ohm 50w B- float resistor is also fine (tested).
Having isolated the problem to the HV supply, I am baffled. I plan to
replace the now-bad diodes, again, but am not sanguine it will work, and I am
running out of 5408s... I don't want to waste bigger diode blocks on this if
they'll short too.
Any advice or suggestions would be appreciated.
73 Dave N3DB
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|