Amps
[Top] [All Lists]

Re: [Amps] What is the meaning of ACVFD ?

To: "Roger \(sub1\)" <sub1@rogerhalstead.com>, <amps@contesting.com>
Subject: Re: [Amps] What is the meaning of ACVFD ?
From: "Carl" <km1h@jeremy.mv.com>
Date: Sat, 2 Jul 2011 21:00:58 -0400
List-post: <amps@contesting.com">mailto:amps@contesting.com>
A 10 HP or higher 3 phase motor and a couple of surplus utility company 
phasing capacitors is the working mans way to tackle it.

Since I dont run that much big 3 phase tools and only one at a time, a 7.5 
HP "idler" motor has been used for over 20 years, it draws negligible power 
to run. The motor cost $50 and the caps were $5 each. There is a surplus of 
3 phase motors these days and the cost would likely be scrap value if you 
shop around.

Carl
KM1H



----- Original Message ----- 
From: "Roger (sub1)" <sub1@rogerhalstead.com>
To: <amps@contesting.com>
Sent: Saturday, July 02, 2011 6:33 PM
Subject: Re: [Amps] What is the meaning of ACVFD ?


> On 7/2/2011 3:17 PM, Paul Kraemer wrote:
>> AC Variable Frequency Drive
>> An electronic motor control that rectifies incoming line voltage (single 
>> or
>> 3 phase) to provide a dc buss voltage (approximately 350vdc for a 230vac
>> drive) which is supplied to a "six pack" array of power devices 
>> (transistors
>> or fets) which is controlled by microprocessor to synthesize a pwm 3 
>> phase
>> output to a motor.
>
> I've been told not depend on the solid state 3 phase converters to run
> much of a motor.  When you get up to a lathe or mill a rotary converter
> works much better and of course costs many times more. <sigh>   For a 7
> HP lathe it takes a 15 to 20 HP rotary converter. (run 2 to 3 times the
> rating of the load)  Too bad too as the solid state converter is a few
> hundred dollars while the rotary converter is $2,000 or more.
>
> 73
>
> Roger (K8RI)
>> Paul K0UYA
>> ----- Original Message -----
>> From:<pdussertvidalet@free.fr>
>> To:<amps@contesting.com>
>> Sent: Friday, July 01, 2011 11:44 PM
>> Subject: [Amps] What is the meaning of ACVFD ?
>>
>>
>>>
>>> What is the meaning of the acronym ACVFD ? Message 1 , vol 103 , from 
>>> Paul
>>> Kouya
>>> .
>>> How can I connect a one phase transformer , 230 volts , on a three 
>>> phases
>>> main
>>> using the three phases to split the power between them ? 73 from Pierre 
>>> /
>>> F8GY .
>>> _______________________________________________
>>> Amps mailing list
>>> Amps@contesting.com
>>> http://lists.contesting.com/mailman/listinfo/amps
>> _______________________________________________
>> Amps mailing list
>> Amps@contesting.com
>> http://lists.contesting.com/mailman/listinfo/amps
>>
>
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
>
> -----
> No virus found in this message.
> Checked by AVG - www.avg.com
> Version: 10.0.1388 / Virus Database: 1516/3740 - Release Date: 07/02/11
> 

_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>