Hi Group,
I am putting together a fairly big amp (4CX3000A) and I've gotten to
the question 'What is a good way to connect to the terminals of the
vacuum output relay?' I'll use big coax up to within an inch or so of
the relay, but then....? Copper ribbon (1/8" or so) and the flexible
shield taken from RG174 or similar have come to mind. I'm
concerned with reliability and noise.
What have you used, and how did you like it?
TIA ES VY 73,
George T Daughters, K6GT
CU in the California QSO Party (CQP)
October 1-2, 2011
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|