Bob, take a look at the link below, they have all kinds of plastic
rivets, they work very well.
http://www.itw-fastex.com/catalog/index.php/dw/op/a/6/c/14/p/27?m=no
http://www.itw-fastex.com/rivets.html
73,
George, K4GVT
On 5/14/2011 4:33 AM, Robert Briggs wrote:
> Hi all...I have been thinking of ways to make Teflon Chimneys for GS-31
> and 35B tubes from 1mm sheet...I am finishing off a 2 meter and a 70cm
> amplifier at present and would like some opinions...
>
> The simplest solution looks to me as making the Teflon tube and
> fastening the join length with brass eylets perhaps one eylet per inch....
>
> My concern is would the small eyelets be subject to RF heating and
> perhaps burning the Teflon sheet at the join??
>
> Thanks all....Bob..VK3ZL..
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|