On 4/15/2011 3:23 PM, Jeff Blaine wrote:
> Nice looking amp, Glen.
>
> 73, Jeff ACØC
> www.ac0c.com
>
> -----Original Message-----
> From: Glen Zook
> Sent: Friday, April 15, 2011 10:08 AM
> To: amps@contesting.com ; Roger (sub1)
> Subject: Re: [Amps] Roller Inductor Choices
>
> I recently built a 160-meter only amplifier using a pair of GI-7bT tubes. It
> was easy to make a socket for them starting with one
> of the $2.99 aluminum mini-boxes that are sold at Radio Shack. The
> cathode/heater ring connections used stainless steel hose clamps
> and the small heater connection used plate caps of the size for 6146 tubes.
>
> There are photos of this socket in the thread at
>
> http://forums.qrz.com/showthread.php?282380-Socket-for-Russian-tubes
>
> Photos of the linear are in the threat at
>
> http://forums.qrz.com/showthread.php?284611-Almost-ready-for-smoke-test!
Very nice looking layout.
One thing I would do differently would be to pressurize the cathode
compartment and build chimneys to direct air up through the anode for
more efficient cooling. But s you are not running the tubes hard I would
think you have sufficient cooling. If plate dissipation is any
indication (and often it's not) a pair of the GI-7Bs should be capable
of about 1200 watts out.
> Glen, K9STH
>
> Website: http://k9sth.com
>
>
> --- On Thu, 4/14/11, Roger (sub1)<sub1@rogerhalstead.com> wrote:
>
> I don't know if the base is the same as the GI-7B but it might be. Check the
> sizes and if they are, there is a guy who makes sockets
> for them on e-bay. You can mount them without sockets but they do need air
> for axial cooling...unless you change the cooler to one
> that works with transverse cooling.
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|