On 4/3/2011 12:54 PM, Patrick Barthelow wrote:
> Gentlemen:
>
> On the Alpha 76A, Gray metal front Plate, 3 holer, 8874 == 3CX400 Eimac
> Tubes,
> Two questions, how does one add a ten meter switch function, (I am told it
> may only require a mechanical stop to be removed in the
> Band switch) and, if one of the thee no longer made 8874 goes, can it
> be run with two of the three remaining?
Last I knew 8874s are still being produced. OTOH they are *EXPENSIVE*
for such a small tube.
http://www.cpii.com/product.cfm/9/22/76
Eimac is now owned by CPII. Econo is also part of the same group.
With a bit of hunting some one on here might have some.
73
Roger (K8RI)
> And if so, do any PI network changes have to be made?
>
> Also, opening one up I am attempting to identify the transformer used, as
> there were sometimes used
> Dahl tranformers, that were lighter than the standard. This transformer is
> huge, open frame design,
> with stacked square laminations, 7.5" wide across the top, and about 3.25
> thick. Dont think it is the Dahl Option.
> Printed on the top laminations is probably a Mfg ID: BTC 11163
> Best Regards,
> Pat Barthelow AA6EG
>
>
>
>
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|