Apparently you are not familiar with the internals of a LK-500. Youre
comment is a later step. Ive also been known to drill my own lubrication
hole when needed.
Id also suggest an EBM/Papst replacement if the original plastic blower is
noisy as there is probably some warpage.
Carl
----- Original Message -----
From: "Roger (K8RI)" <sub1@rogerhalstead.com>
To: <amps@contesting.com>
Sent: Saturday, December 25, 2010 2:32 AM
Subject: Re: [Amps] Blower lube
>
>
> On 12/24/2010 9:21 PM, Carl wrote:
>> Dip the amp into a bucket of oil?
>>
>> Not a good idea? Then the fan has to come out.
>>
> Some (but not all) muffin type fans have a seal on the back of the motor
> that can be lifted and oil put into the bearings there.
>
> 73
>
> Roger (K8RI)
>
>
>> Carl
>> KM1H
>>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|